Inserting The Battery; Connecting The Electrobrush; General Battery Information; Charging The Battery (Without Wall Mounting) - Miele SMUL0 Mode D'emploi

en-US
 Press the release catch to separate
the individual sections from each
other.

Inserting the battery

(Figs. 07, 08 + 09)
 Remove the sticker from the battery.
 Push the battery along the guide lines
until it audibly clicks into place in the
PowerUnit.
 If you want to separate the sections
again, press both release catches at
the side of the battery to remove the
battery.
Connecting the Electrobrush (Fig. 10)
Depending on how your vacuum
cleaner is configured, you can connect
either the PowerUnit connector or the
suction wand connector to the Electro-
brush.
 Insert the connector down into the
Electrobrush from above until it audi-
bly clicks into place.
 To separate the individual sections
from each other, press the release
catch on the Electrobrush and pull
the connector out of the Electrobrush
(Fig. 06).

General battery information

The rechargeable battery is supplied
not fully charged.
Charge the battery completely before
using it for the first time. Allow approxi-
mately 4 hours for this.
It is essential to charge the battery for
the first time in the PowerUnit in order
to activate maximum power in the bat-
tery.
18
Once the battery is fully charged, the
battery charging state indicator
switches off after 10 minutes to con-
serve energy.
You can use the vacuum cleaner for up
to 14 minutes if you are using it in its
fully assembled state at the maximum
power level.
If, however, you are using the
PowerUnit on its own and select the
lowest power level, you can vacuum for
up to 60 minutes.
Charging the battery (without wall
mounting) (Fig. 11)
You can store the vacuum cleaner up-
right and charge the battery directly.
 Connect the PowerUnit to the Elec-
trobrush to provide a secure base for
the vacuum cleaner.
 Swing the vacuum cleaner forwards
until the Electrobrush connector audi-
bly clicks into place.
 Plug the supplied charging cable into
the charging socket on the bottom of
the battery.
 Plug the charger into an electrical
outlet.
The charging process will start.
You can read more about this in "Bat-
tery charging state indicator".
Charging the battery (with wall
mounting) (Figs. 12 + 13)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.