Power And Battery Use; Checking The Clearreader Battery Status; Charging The Clearreader Battery; Extending The Clearreader Battery Life - Optelec ClearReader+ Manuel D'utilisation

Optelec

6. Power and battery use

This chapter only applies to the ClearReader
has an integrated battery. The ClearReader
a mains power source.
6.1. Checking the ClearReader
Press the Back and Forward buttons together to check the battery status of the ClearReader
+
The ClearReader will announce the status in percentage, where 100% means a fully charged
battery. If the battery is low, please charge the battery with the dedicated power supply.
6.2. Charging the ClearReader
To charge the ClearReader
rear side of the unit. Plug the power cord into a power outlet.
Charging the ClearReader
operate for approximately 5 hours. Please note that, for safety reasons, only the power supply
supplied by Optelec should be used to charge the ClearReader
6.3. Extending the ClearReader
To ensure the battery pack maintains maximum capacity, disconnect the ClearReader
power source at least once a month and operate it on battery power until the battery pack is
empty.
53
+
. The ClearReader
+
Basic is AC powered and needs to be powered by
+
battery status
+
battery
+
, connect the power supply to the power connector located at the
+
takes approximately 3 hours. A fully charged ClearReader
+
battery life
ClearReader
+
is the only ClearReader that
+
.
+
+
.
+
can
+
from the
English