The Magnification Feature Pack; Introduction; Connecting The Magnification Feature Pack To The Optelec Clearreader; Magnification Modes - Optelec ClearReader+ Manuel D'utilisation

Optelec

4. The Magnification Feature Pack

4.1. Introduction

The Magnification Feature Pack will add magnification options, as well as advanced navigation,
viewing and reading functionality to your ClearReader
Pack without the monitor to listen to the document captured on the screen, or with the monitor to
magnify it.

4.2. Connecting the Magnification Feature Pack to the Optelec ClearReader

Connect the Magnification Feature Pack to the ClearReader
HDMI connector at the bottom rear side of the ClearReader
you will need to remove the protection cover which will also reveal two USB connectors. Use a
Philips screwdriver to remove the screw which closes the cover. This screw is located in the
middle of the cover at the bottom side of the ClearReader
+
ClearReader by using a HDMI cable. Adjacent to the HDMI connector, there are two USB ports.
Connect the USB cable of the ClearReader
ports on the rear side or to the USB port on the right side of the unit.
When the Magnification Feature Pack is connected to the ClearReader
+
ClearReader and take a snapshot of a document as described in this manual.

4.3. Magnification Modes

With the Magnification Feature Pack, you can view captured documents in different viewing
English
+
or ClearReader
+
and optionally, a monitor. Locate the
+
. If the HDMI connector is not visible,
+
. Connect the monitor to the
+
Magnification Feature Pack to one of the two USB
ClearReader
+
Basic. Use the Feature
+
+
, switch on the
+
34