Push Block - Bosch 4100 Consignes D'utilisation

2610048783.qxp_4100 11/17/17 9:10 AM Page 31
face A is flat against the top of the work-
piece, and Surface B is fully engaged with the
trailing end of the workpiece (Fig. 47). If a
workpiece is shaped such that the push stick
cannot be fully supported in this manner, an
appropriate push block or jig should be used
to support that workpiece.

▼ pUSH BlOCK

When width of rip is narrower than 2" the
push stick cannot be used because the guard
will interfere; use the auxiliary fence and
push block.
Attach auxiliary fence 2 to rip fence with two
"C" clamps (Fig. 48).
Feed the work piece by hand until the trailing
end is approximately 1" from the front edge
of the table. Continue to feed using the push
block 3 on top of the auxiliary fence until the
cut is complete (Fig. 49).
Basic Table Saw Operation
Fig. 47
Fig. 48
Fig. 49
A
B
2
3
31