Adjusting 0 And 45 Degree Positive Stops; Adjusting 0 Degree Positive Stop; Adjusting 45 Degree Positive Stop - Bosch 4100 Consignes D'utilisation

2610048783.qxp_4100 11/17/17 9:10 AM Page 25
▶ Adjusting 0 and 45 Degree
positive Stops
Your saw is equipped with positive stops for
fast and ac curate positioning of the saw
blade at 90 and 45 degrees to the table.
plug from power source when making ad-
justments.
1. Turn elevation wheel 2 clockwise and
raise blade
(Fig. 31).

▼ ADjUSTING 0 DEGREE pOSITIVE STOp:

2. Loosen the blade tilt lock handle 1 and
push the elevation wheel 2 to the left as
far as possible and tighten the blade tilt
lock handle 1 (Fig. 31).
3. Place a combination square on the table
with one end of square against the
blade as shown (Fig. 32), and check to
see if the blade is 90 degrees to the
table. If the blade is not 90 degrees to
the table, loosen the blade tilt lock han-
dle 1, loosen 90 degree adjustment
screw 4, loosen 90 degree bevel stop
cam 5 and push the elevation wheel
until the blade is 90 degrees to the
table.
4. Tighten blade tilt lock handle 1, rotate
the bevel stop cam 5 until it touches the
bevel stop housing 7, then tighten 90
degree adjustment screw 3.
5. Loosen adjustment screw 6 and adjust
pointer 3 to indicate 0 degrees on the
bevel scale.

▼ ADjUSTING 45 DEGREE pOSITIVE STOp:

6. Loosen the blade tilt lock handle 1 and
push the elevation wheel 2 to the right
as far as possible and tighten the blade
tilt lock handle 1.
7. Place a combination square on the table
with one end of square against the blade
as shown (Fig. 33), and check to see if
the blade is 45 degrees to the table. If
the blade is not 45 degrees to the table,
loosen the blade tilt lock handle 1,
loosen 45 degree adjustment screw 8,
loosen 45 degree bevel stop cam 9 and
push the elevation wheel until the blade
is 45 degrees to the table.
Adjustments
To prevent personal in-
jury, always dis con nect
to maxi mum height
5 4 3 1
6 7
8. Tighten blade tilt lock handle 1, rotate
the 45 degree bevel stop cam 9 until it
touches the bevel stop housing 7, then
tighten 45 degree adjustment screw 8.
Fig. 31
9 8
2
Fig. 32
Fig. 33
25