Publicité
Les langues disponibles
Les langues disponibles
GB
DECELARATION TIME PROGRAMMING
If you wish to have decelerations values different from the factory settings, you must execute the time learning stage with
before the wing reaches the end-of-travel position.
PROGRAMMING OF PEDESTRIAN OPENING (only for automations with one motor, dip-switch 11 to OFF)
1
7
1 and 2 - When the gate is in mid-travel position, disconnect the power supply to the control unit.
4, 5 and 6 - Power the control unit while holding down the STOP/PROG. button for at least 3 seconds. Programming Led L1 will
8 - When the gate strikes the closing stop, activate the pedestrian control again if there are no limit switches or encoder or MAS200.
9 - The gate will start opening.
10 - When the desired pedestrian opening position is reached, activate the pedestrian control. The gate will stop and start closing again.
11 - When the gate strikes the closing stop, activate the pedestrian control again if there are no limit switches or encoder or MAS200.
12 - The motor will stop and Led L1 will go out.
INDEPENDENT PAUSE TIME PROGRAMMING
This procedure allows you to modify the pause time without having to completely re-.program the control unit.
1 - With the gate closed disconnect the power supply to the control unit.
3, 4 and 5 - Power the control unit while holding down the STOP/PROG. button for at least 3 seconds. Programming Led
66
2
3
9
8
PED
PED
4
5
10
11
PED
PED
6
12
Publicité
