Publicité
Les langues disponibles
Les langues disponibles
GB
TYPE 1
AUTOMATION OF 2 MOTORS WITHOUT ELECTRIC LIMIT SWITCHES, WITHOUT ENCODER AND WITHOUT MAS200
1
7
13
19
Programming:
1 - Disconnect the power supply to the control unit.
2 - Bring the gate to mid-travel position.
the reverse direction, disconnect the power supply, exchange the motor phase wires and repeat the procedure).
8 and 9 - When it reaches the stop point press button P/P. Motor M2 will stop while motor M1 will automatically start
closing (wing with electric lock).
10 and 11 - When M1 also reaches the stop position, press button P/P. The motor will stop and then start again in the
opening direction.
12 -During this manoeuvre, the space offset of the two opening wings must be selected. In order to set the time delay,
press button P/P when the wing driven by motor M1reaches the point where the wing driven by motor M2 should
start moving.
13 -Motor M1 stops momentarily and then starts opening the wing again.
14 -Press button P/P when the wing driven by motor M1 has opened all the way.
15 -The wing driven by motor M2 will automatically start opening.
2
3
8
9
14
15
21
20
4
5
10
11
16
17
22
23
6
12
18
24
61
Publicité
