Publicité
Les langues disponibles
Les langues disponibles
GB
TYPE 4
AUTOMATION OF 1 MOTOR WITH ELECTRIC LIMIT SWITCHES OR ENCODER
1
7
13
Before programming:
-
- Make sure the motor is connected to M1 (terminals 1 - 2 and 3 )
- Adjust the limit switches before performing the self-learning procedure.
he optional anti-crushing module MAS200 may be connected only after the self-learning procedure has been
carried out.
Programming:
1 - Disconnect the power supply to the control unit.
2 - Bring the gate to mid-travel position.
disconnect the power supply, exchange the motor phase wires and repeat the procedure)
8 and 9 - When it reaches the stop point the motor will stop and then will automatically start opening.
10 -When the gate has opened all the way the motor will stop.
11 - Allow the desired pause time to elapse before re-closing.
12 -When the desired pause time has elapsed, press button P/P: the gate will close again.
13 and 14 - When the gate has closed all the way the motor will stop and Led L1 will go out.
*Note: if dip-switch 9 is set to the ON position after the programming procedure has been completed, the
control unit will execute factory-set decelerations. To modify the deceleration settings, see the chapter
titled DECELARATION TIME PROGRAMMING.
2
3
9
8
14
4
5
10
11
6
12
65
Publicité
