Publicité
Les langues disponibles
Les langues disponibles
GB
16 -Press button P/P when the wing driven by motor M2 has opened all the way.
18 -When the desired pause time has elapsed, press button P/P: motor M2 will start closing.
delay, press button P/P when the wing driven by motor M2 reaches the point where the wing driven by motor M1
should start moving. Motor M2 stops momentarily and then starts closing the wing again.
21 -Press button P/P when the wing driven by motor M2 has closed all the way.
22 -The wing driven by motor M1 will start closing.
23 and 24 - Press button P/P as soon as the wing driven by motor M1 has completed the closing manoeuvre. Led L1 will go out.
*Note: if dip-switch 9 is set to the ON position after the programming procedure has been completed, the
control unit will execute factory-set decelerations.
To modify the deceleration settings, see the chapter titled DECELARATION TIME PROGRAMMING
TYPE 2
AUTOMATION OF 2 MOTORS WITH ELECTRIC LIMIT SWITCHES OR ENCODER (or with MAS200 module)
1
7
13
19
62
2
3
8
9
14
15
20
21
4
5
10
11
16
17
22
23
6
12
18
24
Publicité
