Device Care; Maintenance; Troubleshooting - I-Tech T-ONE REHAB Notice D'utilisation

Maintenance

If used following the instructions given in this user guide, the equipment does
not require any particular kind of maintenance.
CLEANLINESS
Clean the device using only a dry soft cloth. Resistant strains can be removed
using a sponge soaked in solution of water and alcohol.
Device not subject to sterilization.
TRANSPORTATION AND STORAGE
Precaution for the transportation
There is no particular precaution to be taken during transportation of the
device, since T-ONE REHAB is a portable device. In any case it is
recommended to store T-ONE REHAB and its accessories in the supplied
carrying bag after each treatment. Protect the device from high temperature,
direct daylight and liquids. Store the device in a cool, well-ventilated place. Do
not store heavy objects on the device.
Precaution for the storage
The performances of the equipment are granted if it is stored according to
the following conditions:
During operation
Temperature
Relative humidity
Pressure
Inside the supplied carrying bag:
Temperature
Relative humidity
Pressure

Troubleshooting

In case of any malfunctions or problems when using T-ONE REHAB, see the
indications below:
T-ONE REHAB does not start and/or the display does not turn on.
•
Check the batteries level and replace them if exhausted (see chapter
"Replacing the batteries"). Make sure the batteries are correctly
inserted. If the problem persists, contact the manufacturer.
T-ONE REHAB does not transmit electrical pulses. Make sure you
•
have connected the cables with the electrodes and check if the
IACER Srl
from +5 to +40°C
from 30 to 75%
from 700 to 1060 hPa
from -10 to +55°C
from 10 to 90%
from 700 to 1060 hPa
151

Device care

MNPG236-02