I-Tech T-ONE REHAB Notice D'utilisation page 106

Table of the main drugs used in the iontophoresis treatments
Drug
Ketoprofen, lysine salt
Thiomucase
If the prescribed drug does not appear on the above list, check the polarity
indicated on the package or on the warnings of the drug itself or consult your
doctor/pharmacist.
Before starting the ionophoresis session, clean the skin near the area to be
treated; connect the jacks of the electrostimulation cable to the black rubber
electrodes with cable disconnected from T-ONE REHAB.
Moisten the two sponge electrodes abundantly.
ATTENTION: wring the sponge electrodes to avoid dripping, then put
the drug on an electrode as follows:
•
•
At this point, insert the two black rubber
electrodes, previously
electrostimulation cable inside the sponge
coverings (one with the drug and the other
without). Position the electrode with the drug on
the painful area, and the other electrode on the
other side (Figure 2) with the help of the elastic
band supplied with the kit. Connect cable at the
appropriate jack (channel 1) and turn T-ONE
REHAB on.
IACER Srl
Polarity
Pos/Neg
Negative
• drugs with positive polarity: dissolve this type of
drug on the electrode connected to the positive pole (red
connection, cathode).
Drugs with negative polarity: dissolve this type of drug on
the electrode connected to the negative pole (black
connection, anode).
Bipolar drugs: these can be dissolved on either the positive
pole or the negative pole.
connected
Prevalent action
Anti-inflammatory
Anti-oedemic
to the
Figure
electrodes placed at the ends of
the muscle to be stimulated.
102
Indications
myalgia
Osteoarthritis,
arthritis
Post-traumatic and
post-operative
edema due to
venous
insufficiency.
2 – Positioning
MNPG236-02
of