Section One: General Safety Instructions; Electrical Requirement And Grounding Instructions; Safety Precautions - Thermador Professional P24GE Manuel D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour Professional P24GE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 1: GENERAL SAFETY INSTRUCTIONS
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
PLEASE READ CAREFULLY
All Cooktop models and the Wok require an electri-
cal circuit rated at 120 volts, 60 Hz., 10 Amps, ex-
cept models with electric griddle require 15 Amp cir-
cuits. Electric griddles 24" wide are 240 volt models
which require 30 Amp circuits.
For personal safety, this appliance must be con-
nected to a properly grounded and polarized
electrical power supply.
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
See Installation Instructions for electrical
requirements and grounding instructions.
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5 min-
utes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners and grill manually, carefully hold a lighted match to the burner ports
and turn the gas control knob to HI. During a power failure, you can manually light the standard
cooktop burners and grill only, but each must be lit with a match.
DO NOT attempt to light the two left burners manually. These burners are equipped with
the ExtraLow® feature and cannot be lit manually.
See Pages 11 and 20 for additional information on manually lighting the burners.

Safety Precautions

CAUTION
CAUTION - ALL MODELS
2
DO NOT UNDER ANY
CIRCUMSTANCES CUT OR REMOVE
THE SEPARATE GROUND WIRE OR
THE THIRD (GROUND) PRONG FROM
THE POWER CORD PLUG.
It is the personal responsibility and obligation of you,
the user, to have this appliance connected to the
electrical power supply in accordance with the Na-
tional Electrical Code and/or applicable local codes
and ordinances by a qualified electrician.
It is recommended that a dedicated circuit servicing
this appliance be provided.

Publicité

Chapitres

Table des Matières
loading

Table des Matières