Transporting And Storing - Sage Barista Touch BES880 Guide Rapide

REPLACING THE SILICONE SEAL
Over time, the silicone seal surrounding the shower
screen will need to be replaced to ensure optimum
brewing performance.
1. Press the POWER button to switch the
machine off and unplug the cord from the
power outlet.
2. Carefully remove the water tank and drip tray,
taking particular care if they are full.
3. Using a skewer or similar, clean the centre
of the screw of any residual coffee.
4. Insert a flat head screwdriver into the centre
of the screw. Turn counter-clockwise to loosen
the screw.
Clean centre of screw
before inserting flat head
screwdriver.
5. Once loosened, carefully remove and retain
the screw and the stainless steel shower
screen. Make note of the side of the shower
screen that is downwards. This will make
re-assembly easier. Wash the shower screen
in warm soapy water, then dry thoroughly.
6. Remove the silicone seal with your fingers or
a pair of long-nose pliers. Insert the new seal,
flat side first, so the ribbed side is facing you.
7. Re-insert the shower screen, then the screw.
With your fingers, turn the screw clockwise for
2‑3 revolutions then insert flat head screwdriver
to tighten until the screw is flush with the
shower screen. Do not overtighten screw.
8. Re-insert the drip tray and water tank.
Contact Sage Consumer Support or visit the
Sage webpage for replacement silicone seals
®
or for advice.

TRANSPORTING AND STORING

Press the POWER button to switch the machine
off and remove the plug from the power outlet.
Remove unused beans from the hopper, clean
the grinder, empty the water tank and the drip tray.
Ensure the machine is cool, clean and dry. Insert
all accessories into the storage tray. Store upright.
Do not place anything on top.
EN
17