Sage Barista Touch BES880 Guide Rapide page 16

CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand with
a damp cloth.
• If any of the holes in the tip of the steam wand
become blocked, it may reduce frothing
performance.
• Go to 'Settings' > 'Steam wand cleaning' and
follow the guide on the screen.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter should be rinsed
under hot water immediately after use to remove
all residual coffee oils.
• If any of the holes in the filter basket become
blocked, use the pin on the end of the provided
cleaning tool to unblock the hole(s).
• If the hole(s) remain blocked, dissolve a cleaning
tablet in hot water and soak filter basket and
portafilter in solution for approx. 20 minutes.
Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
should be wiped with a damp cloth to remove
any ground coffee particles.
• Periodically purge the machine. Place an empty
filter basket and portafilter into the group head.
Touch the 'Brew' button and run a short flow of
water to rinse out any residual coffee.
CLEANING THE DRIP
& STORAGE TRAY
• The drip tray should be removed, emptied and
cleaned at regular intervals, particularly when
the drip tray full indicator is showing EMPTY ME!
• Remove the grill from the drip tray.
Lift the coffee grind separator and dispose of
any coffee grounds. The EMPTY ME! indicator
can also be removed from the drip tray by pulling
upwards to release the side latches. Wash all
parts in warm soapy water with a soft cloth.
Rinse and dry thoroughly.
• The storage tray (located behind the drip tray)
can be removed and cleaned with a soft, damp
cloth. Do not use abrasive cleansers, pads
or cloths which can scratch the surface.
16
NOTE
All parts should be cleaned by hand using warm
water and a gentle dish washing liquid. Do not
use abrasive cleansers, pads or cloths which can
scratch the surface. Do not clean any of the parts
or accessories in the dishwasher.
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
The outer housing and cup warming tray can be
cleaned with a soft, damp cloth. Polish with a soft,
dry cloth. Do not use abrasive cleansers, pads
or cloths which can scratch the surface.
STORING YOUR MACHINE
Before storing, press the POWER button to
switch the machine off and remove the plug from
the power outlet. Remove unused beans from the
hopper, clean the grinder (see page 15), empty the
water tank and the drip tray. Ensure the machine
is cool, clean and dry. Insert all accessories into
the storage tray. Store upright. Do not place
anything on top.
WARNING
Do not immerse power cord, power plug
or appliance in water or any other liquid.