ATIKA ASP 4 N Notice Originale page 12

Regularly check the extension cables and replace them if
they are damaged.
Do not use any defective connection cables.
When working outdoors, only use extension cables especially
approved and appropriately labelled for outdoor use.
Do not set up any provisional electrical connections.
Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician or
one of our customer service points. Local regulations –
especially regarding protective measures –
observed.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.
D e s c r i p
D e s c r i p
Fig. 1
ASP 4 N
Fig. 2
ASP 5 N
A Log ram
B Bleed screw
C Piston rod
D Dipstick
E Cylinder cover
12
t i o n o f d e v i c e
t i o n o f d e v i c e
F Electric motor
G Operating pushbutton
H Splitting wedge
I Log guide plates
J Operating lever
Position the log splitter on a work surface at a height of about
60 – 75 cm, this will create an comfortable working position.
Place chocks under the wheels to prevent the machine rolling
during operation.
Ensure that the working area meets the following conditions:
− no danger of slipping
− level
− free of obstacles
must be
− sufficiently well lit
Do not operate the machine in the direct vicinity of gas or petrol
pipes or containers, or any other easily inflammable materials.
Check that the machine is completely and correctly
assembled.
Before using the shredder, make sure each time that
there are no faulty connections (tears, cuts, etc.)
−
there are no damage at the machine
−
all screws are tight
−
check the hydraulic system for any possible leaks
−
Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the machine to the
relevant and properly earthed plug.
Only use connection cables with sufficient diameters.
Connect the machine via a 30 mA fault current safety switch.
Fuse protection: 10 A
Operating pushbutton
Fig. 3
Switching on
Push the green button. The motor is running as long as the green
button remains pushed.
Switching off
Stop pushing the green button.
Do not use any device where the operating pushbutton
does not work properly. Repair or replace damaged pushbuttons
immediately.
P o s i t i o n i n g
P o s i t i o n i n g
S t a r t - u p
S t a r t - u p