Control - attika RAIS VISIO 1 Mode D'emploi

English
• When the fire has caught the kindling wood, close the door completely (photo 5)
(after approx. 3-10 min., depending on the draft conditions in the chimney).
• When the last flames are extinguished and there is a nice layer of embers (photo
6), add 3-4 pieces wood - about 2-2½ kgs (photo 7).
• Close the door completely.
• If necessary set the air damper in position 3 (to the right) for 2-5 min. to start the
fire (photo 8).
• Adjust the damper between pos. 1 and 2 (see 'Adjustment of air damper').
NOTE!
If the fire has burned down too low (too small an ember), it may take longer time to
get the fire going again. In order to light up the fire, it is recommended to use kindling
wood.
When firing the smoke out of the chimney should be almost invisible; just a 'flicker' in
the air is opserved.
When refueling, open the door carefully to avoid smoke escaping. Never add wood
while it is burning (flames!) in the stove.
RAIS recommends to refuel with 2-4 pieces wood - approx. 1½ - 2½ kg - within
49 minutes (intermittent operation).
ATTENTION!
Keep an eye on the stove when lighting.
During operation the door should always remain shut.
Be careful, as all external surfaces will be very hot to touch when in operation.

Control

Look for signs that indicates a correct firing in the stove:
• ash is white
• the walls in the combustion chambers are free from soot
Conclusion: the wood is sufficiently dry
attika
RAIS/ - User manual for VISIO
59 59