attika RAIS VISIO 1 Mode D'emploi page 149

English
Adequate provision e.g. easily accessible soot door or doors must be provided for
sweeping the chimney and connecting fluepipe.
You should also familiarise yourself with the draught conditions for chimneys with 2
flues.
The stove is supplied with a ø200 mm flue outlet spigot.
The stove is approved with a ø180 mm flue outlet spigot, which can be retrofitted.
The flue spigot can be changed from top outlet to back
outlet. The clamp on the outlet is loosened and
adjusted as desired.
NOTE!
if the stove is installed with a back outlet, the back wall
must be non combustible ( e.g.a brick wall).
For strong draughts, the chimney or flue should be fitted
with a draught stabiliser. In which case, it is important to
ensure that there is a free flow-through area of minimum
20 cm² when the regulating gate is shut. Otherwise, the
fuel energy may not be used optimally. If, at any time, you
are unsure about the condition of the chimney, you should contact a chimney sweep.
Remember that access to the access door should be kept clear.
Make sure to establish access to cleaning the stove, flue collar and pipe.
attika
RAIS/ - User manual for VISIO
19 19