Télécharger Imprimer la page

Beurer BC 20 Mode D'emploi page 14

Masquer les pouces Voir aussi pour BC 20:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
• When the 180 mmHg pressure is reached, the pres-
sure is automatically released from the cuff and a
beating heart appears in the display.
• Your blood pressure readings and pulse rate will then
appear in the display.
• To switch off and release the pressure, press the
Start /Stop button
• If you forget to switch off the computer, it will switch
off automatically after 3 minutes.
• You can interrupt measurement at any time by press-
ing the Start /Stop button
8. Display of the readings saved
The computer automatically saves the blood pressure
readings of the last 60 measurements.
When the 60 memory locations are exceeded, the cur-
rent oldest value is deleted.
You can display the memory as follows:
• Press the memory button M
switched off. The last reading measured appears.
• You can call up all individual readings saved by press-
ing the memory button M repeatedly.
• The memory location number is shown in the display
at bottom right. The date and time of the individual
measurement are shown in the top part of the display.
again.
.
with the computer
• The last result obtained is stored in the first memory
location. As soon as a new result is obtained, this ap-
pears in the first memory location and the older result
moves down to the next location.
• After the last memory location occupied, the com-
puter shows the average of all readings saved on
pressing the memory button M
• To switch off, press the Start /Stop button
• If you forget to switch off the computer, it will switch
off automatically after 3 minutes.
9. Rectifying faults
Error messages can occur when
• cuff inflation takes longer than 25 seconds (
pears in the display),
• you move during the measurement instead of relaxing
quietly (
appears in the display),
• insufficient pressure is reached despite extra inflation
(
appears in the display),
• the blood pressure readings are extremely high or low
(
appears in the display),
• the inflation pressure is higher than 300 mmHg (error
message
• the batteries are almost exhausted, the batteries must
then be exchanged.
14
again.
),
again.
ap-

Publicité

loading