Storage; Waste Disposal And Environmental Protection - AL-KO BKS 4540 Traduction Du Mode D'emploi Original

en
WARNING!
The table contains a list of all possible combinations between bar and chain, indicating those
which may be used on each machine, marked with the symbol "*".
Pitch
Zoll Length In-
ches/cm
0.325" 16"/40cm
For replacement use only above bars and chains. If you use non-approved combinations it may cause
serious personal injury and damage to the machine.

STORAGE

1 Empty the fuel tank and run the engine out of fuel.
2 Empty the oil tank.
3 Clean the entire unit.
4 Store the unit in a dry place out of the reach of children.
5 Putting the cover of the guide rail on always at storage and transportation.

WASTE DISPOSAL AND ENVIRONMENTAL PROTECTION

Never pour remainders of chain lubricant or 2-stroke fuel mixture in the drain or sewerage system or soil,
but dispose of it in a proper, environmentally friendly way, e.g., at a special collecting point or dump.
If your device should become useless somewhere in the future or you do not need it any longer, do not
dispose of the device together with your domestic refuse, but dispose of it in an environmentally friendly
manner. Thoroughly empty the oil/lubricant and fuel tanks and dispose of the remainders at a special
collecting point or dump. Please also dispose of the device itself at an according collecting/recycling
point. By doing so, plastic and metal parts can be separated and recycled. Information concerning the
disposal of materials and devices are available from your local administration.
46
Guide bar
(1) Ruler
Guide bar
Groove width
Inches/mm
0.058"/1.5mm
168PXBK095
Reverse the bar occasionally to prevent partial
wear.
The bar rail should always be a square. Check
for wear of the bar rail. Apply a ruler to the bar
and the outside of a cutter. If a gap is observed
between them, the rail is normal. Otherwise, the
bar rail is worn. Such a bar needs to be correc-
ted or replaced.
(2) Gap
Chain
Code Code
Oregon Oregon
21BPX066X
Storage
(3) No gap (4) Chain
tilts
Chain saw
model
BKS 4540
*
BKS 4540