Regulations / Outside Air Intake - Bio Bronpi CAROL-MIXTA Instructions D'installation, D'utilisation Et D'entretien

Only wood pellets certified by these rules should be used:
Standards:
• Ö-Norm M 7135 | Din 51731 | EN-14962-2 (repealed and covered on ISO-17225-2)
• ISO-17225-2
Quality certifications:
• DIN+
• ENplus: on website (www.pelletenplus.es) you can check all the manufacturers and distributors with current certificate.
• It is highly recommended the pellet would be certified with a quality standard because of is the only way to guarantee a constant pellet
quality.
• Bronpi Calefacción recommends the use of pellets with 6 mm diameter, a maximum longer of 3.5 cm and with a humidity percentage
lower than 8%.
• STORAGE OF PELLET
In order to guarantee combustion without any problem it is necessary to keep the pellet in a dry ambient.
• PELLET SUPPLY
Open the tank cover on the top of the equipment and empty directly the pellet bag taking care of not overflowing.
LOGS
Use only dry firewood (max. moisture content 20%, which corresponds to firewood that was cut two years ago). The length of the logs will
depend on the model (you can check the technical features of each model in our web site www.bronpi.com).
Compressed wood briquettes must be used carefully in order to avoid harmful overheating of the equipment because they have a high
calorific power.
The wood used as fuel must be stored in a dry place. Damp firewood has approximately 60% of water. Therefore, it is not suitable to be burnt
because it makes the ignition more difficult due to the fact that the heat is used to vaporize the water. Moreover, the moisture content has also
the disadvantage that, when the temperature is lower
the water condenses in the fireplace and the chimney. This causes the soot accumulation and condensation, with the consequent risk of fire.
Among others, it is not allowed to use> coal, barks and panels, damp firewood or with paint or plastic materials. In these
cases, the warranty of the stove shall terminate. It is forbidden to use waste and it would damage the equipment.
Paper and cardboard should only be used during the ignition.
Below is an instructions table about the type of firewood and the quality for the combustion.
TYPE OF WOOD
HOLM OAK
ASH TREE
BIRCH TREE
ELM TREE
BEECH
WILLOW
FIR TREE
WILD PINE
POPLAR
4.

REGULATIONS / OUTSIDE AIR INTAKE

WOOD WORKING
The stove is provided of some adjustments to get a perfect regulation of the combustion when is working under "wood" mode:
The primary air intake controls the air that passes through the ash pan and the grate towards the fuel. The
primary air is necessary for the combustion process.
The ash pan should be emptied frequently so that the ash does not block the primary air intake for the combustion.
Also, the primary air rekindles the fire.
This control is placed on the bottom left side of the stove's door and the movement is from inside to outside and
vice versa. The operation to outside means a greater entry of air.
The secondary air intake favours the carbon that was not burnt during the first
combustion can suffer a post-combustion. This increases the efficiency and
assures that the glass keeps clean. This air intake is not adjustable.
Double combustion
This model includes the double combustion. With this system we get a second preheat entry air. This allows a
second combustion of the gases not burnt in the first combustion that achieves a high performance efficiency, a
great fuel saving and reductions in pollutant emissions.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
QUALITY
OPTIMAL
VERY GOOD
GOOD
GOOD
GOOD
NOT ENOUGH
NOT ENOUGH
INSUFFICIENT
INSUFFICIENT
25 CAROL-MIXTA