Bio Bronpi CAROL-MIXTA Instructions D'installation, D'utilisation Et D'entretien page 43

WOOD WORKING
This time, when the stove is in wood mode, it is only possible to watch on display the overheating alarm reached inside the pellet tank
whenever the user has the stove connected to the electrical network and it has been ignited from the display. Otherwise, the safety device will
not show the alarm signal.
However, during the wood working, we can see the next working problems of the stove, whose possible reasons and possible solutions are
described on the next table:
PROBLEM POSSIBLE REASON
The stove gives
Inappropriate use of the stove
off smoke
Smoke duct is cold
Smoke duct is obstructed
Smoke duct is oversized
Smoke duct is tight
The draught is not enough
Pellet / Wood automatic system blocked
Smoke duct with infiltrations
More than one equipment connected to the
duct
Air returns
Inappropriate use of the stove
Combustion range too low. Lack of draw
Excessive ash accumulation
The smoke duct does not protrude the top
of the roof
Combustion out The door is not sealed properly or is open
of control
Excessive draw
Refractory sealing plaster is damaged
Smoke duct is oversized
Strong winds
Green or wet wood with bad quality
Insufficient heat Green or wet wood with bad quality
Lack of primary air
Smoke duct with air infiltrations
Masonry exterior of the chimney is cold
Heat loss in the house
** The note PROFES means that the task must be done by a professional.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
SOLUTION
Open the primary air intake a few minutes and then open
the door
Pre-heat the stove
Check the duct and the connector to see if it is blocked or
has an excessive soot
Install an appropriate diameter
Install an appropriate diameter
Add length to the chimney
Unblock the system
Seal connections between sections
Disconnect the rest of equipments and seal the entrances
Open completely the primary air intake and, later, the door
during a few minutes
Use the stove with an appropriate range. Increase the
primary air intake
Empty the ash pan frequently
Add length to the chimney
Close the door or change the sealing cords
Check the installation or install a draft-diverter valve
Check the joints and use refractory putty
Install an appropriate diameter
Install an appropriate chimney cowl
Use dry wood. Air dried during at least 1 year
Use dry wood. Air dried during at least 2 years
Increase the primary air intake
Use an insulated system of chimney
Insulate thermally the chimney
Seal windows, openings, etc
42
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
CAROL-MIXTA