13. Alarms - Bio Bronpi CAROL-MIXTA Instructions D'installation, D'utilisation Et D'entretien

13. ALARMS

PELLET WORKING
In case of an anomaly during the operation in pellet mode, the electronics of
the stove intervenes and highlights the irregularities that have happened in
the different working phases, depending on the type of fault.
Every alarm situation makes the stove to be automatically blocked. By
pressing button P2 (for 3 seconds) we unblock the stove, for that, on display
we will read "stop", other way is not possible the unblocking. Once the stove
has reached the appropriate cooling temperature, the user can restart it up.
The following table shows the list of alarm codes as well as a description:
ALARM
Er01 Intervention of the safety thermostat, even when the stove is turned off
Er02 Intervention of the safety air pressure switch, only when the smoke fan is working.
Er03 Switching off of the stove due to smoke temperature decrease Possible lack of fuel or blockage of it.
Er05 Switching off of the stove due to overheating of the smoke temperature
Er07 Error Encoder: the encoder of the smoke extractor does not receive signal
Er08 Error Encoder: the adjustment of the smoke extractor speed is not possible
Er11 Values DATE/TIME are not exact after a long power failure
Er12 Ignition of the stove unsuccessful
Er15 Power dip
Er17 The hot air tangential fan does not regulate
Er29 Automatic system that controls the pellet / wood working is blocked.
Er39 Flow sensor broken
Er41 The primary air flow is not enough during the check-up of the stove
Er42 The primary air flow is high
Besides the failure codes, the stove can show the following messages that do not block its operation:
MESSAGE
Prob Anomaly on the probes control in check-up.
Service This message means that the operating hours have been reached (1200). It is necessary to call the technical assistance
service.
Block Ignition This message appears when the system has not been turned off manually during the Ignition phase (after the preload): the
system will turn off when it works at full capacity.
Link Error Fail of communication between the card and the keyboard (display)
Stand-by Automatic system that controls the pellet / wood working is into operation.
Cleaning on Doing a periodic cleaning. Only shown in pellet mode.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
11:30
30º
20º
Er 12
DESCRIPTION
DESCRIPTION
41 CAROL-MIXTA