Changing The Audio Channel; Adjusting The Audio Output Level - Dvd Level - Sony XAV-W1 Mode D'emploi

1
During playback, touch "DVD
CONTROL."
2
Touch "Audio" repeatedly until the
desired audio language/format
appears.
Audio language
Audio format/channel numbers*
The audio language switches among the
available languages.
When the 4-digit input prompt appears, input
the language code (page 59) for the desired
language.
When the same language is displayed two or
more times, the disc is recorded in multiple
audio formats.
* The format name and channel numbers appear as
follows.
Example: Dolby Digital 5.1 ch
Dolby D 3 / 2 . 1
Front component × 2 +
Center component × 1
To close the DVD control menu, touch "DVD
CONTROL."
22
Rear component × 2
LFE component × 1

Changing the audio channel

When playing VCD/CD/MP3/WMA, you can
select the right or left channel sound to listen
through both right and left speakers.
The options are indicated below.
Stereo: Standard stereo sound (default)
1/Left: Left channel sound (monaural)
2/Right: Right channel sound (monaural)
For VCD
1
During playback, touch "PLAY MODE,"
then touch "Sound" repeatedly until
the desired audio channel appears.
Audio channel
To close the play mode menu, touch "PLAY
MODE."
For CD/MP3/WMA
1
During playback, press (AUDIO) on the
card remote commander repeatedly
until the desired audio channel
appears.
Note
You may not be able to change the audio setting
depending on the disc.
Tip
The operation by the card remote commander
(pressing (AUDIO) repeatedly) is also available for
video discs.
Adjusting the audio output level
— DVD level
The audio output level differs depending on the
recorded format. To reduce the volume level
differences between disc and source, you can
adjust audio output level according to the
recorded format. The default level is set for PCM
format, and the level for Dolby Digital and DTS
format can be adjusted separately from the
default level.