Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.7
Setting the dialling mode
There are two types of dialling mode:
•
DTMF/Tone dialling (the most common)
•
Pulse dialling ( for older installations )
To change the dialling mode:
1.
Enter the menu by pressing
2.
Select setup using the up
3.
Press OK
4.
Select DIAL MODE using the up
5.
Press OK
6.
Select the dialling mode using the up
7.
Press OK to validate
4.8
flash time duration
1.
Enter the menu by pressing
2.
Select SETUP using the up
3.
Press OK
4.
Select RECALL using the up
5.
Choose RECALL 1 for short flash time (100ms) or RECALL 2 for long flash time
(250ms)
4.9
Automatic answer
When there is a incoming call and the handset in on the base, the phone automatically takes
the line when lifted. This is the default setting, but can be set OFF:
1.
Enter the menu by pressing
2.
Select HANDSET using the up
3.
Press OK
4.
Select AUTO ANSWER using the up
5.
Select ON (for automatic answer) or OFF
6.
Press OK
4.10 Reset
It is possible to return the phone to the original default configuration. This is the configuration
which was installed when you first received the telephone.
To return to default settings:
1.
Enter the menu by pressing
2.
Select SETUP using the up
3.
Press OK
4.
Select DEFAULT using the up
5.
Press OK
6.
Enter the 4 digit PIN code (default =0000). Press OK.
7.
Press again OK to validate
Topcom Butler 4502/Twin/Triple/Quattro
/OK
and down
keys
and down
and down
/OK
and down
keys
and down
keys
/OK
and down
keys
and down
/OK
and down
keys
and down
keys
Topcom Butler 4502/Twin/Triple/Quattro
keys
keys
keys
17
Publicité
Chapitres
Table des Matières
Dépannage
