Mounting The S9M; Mounting With Tension/Compression Bars - HBM S9M Notice De Montage

Masquer les pouces Voir aussi pour S9M:

Table des Matières

Les langues disponibles

S9M

Rigid

force transfer

Fig. 5.1

Transducer orientation during mounting

NOTE

Please note the maximum permissible loading capacity of the mounting parts

used and of the tension/compression bars, screws and knuckle eyes.

5.3 Mounting the S9M

In this mounting variant, the transducer is mounted with tension/compression

bars on a construction element and can then be measured in the tensile and

compressive directions. Alternating loads are also correctly recorded if the

transducer is mounted without axial play. For dynamic alternating loads, the

upper and lower threaded connectors must be pre-stressed to above the

maximum operating load and then locked in place.

1. Installation and locking with initial stress (recommended mounting variant):

• Screw in the threaded connector

• Pre-stress transducer to 110 % operating load in the tensile direction

• Hand-tighten locknut

• Relieve the transducer

A3019-5.0 en/de/fr

correct

Rigid

force transfer

incorrect

HBM

Table des Matières

Table des Matières