HBM S9M Notice De Montage page 15

S9M
• Unscrew knuckle eye 1 to 2 threads and align
• Pre-stress knuckle eye to 110 % operating load in the tensile direction
• Hand-tighten locknut
• Relieve the transducer
2. Installation of knuckle eye and locking with torque:
• Unscrew locknut up to the eye
• Screw the knuckle eye into the transducer (note permissible thread
reach)
• Align knuckle eye
• Tighten the locknut with the following torques
Nominal (rated)
force in kN
0.5 ... 1
2 ... 10
20
50
NOTE
When locking, the tightening torque must not be shunted through the trans­
ducer.
A3019-5.0 en/de/fr
Thread on transducer
M8
M12
M24X2
M24X2
Tightening torque in NVm
15
50
200
500
15
HBM