RAMSEY WINCH H 49,8 Série Traduction Des Instructions Originales page 13

FIGURE 13
Press bearing #40 onto worm #35. NOTE: Be sure
that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away
from worm threads. Press bearing and worm into
gear housing. Slip gasket #62 onto bearing cap #18.
Use six capscrews #52 to secure bearing cap to
gear housing. Tighten capscrews to 16.1 Nm (12 ft
lb) each. Place key #25 into keyway of worm #35.
FIGURE 13
FIGURE 14
Attach adapter #2 to gear housing using six
capscrews #51. Tighten capscrews to 16.1 Nm
(12 ft lb) each. Insert key #25 into keyway of worm
shaft. Slide tapered end of coupling #1 over end of
worm shaft.
Place motor shaft, with key in keyway, into coupling.
Secure motor #67 to adapter, using two capscrews
#52. Tighten capscrews to 53 Nm (39 ft lb) each.
FIGURE 14
FIGURE 15
Place winch with gear housing cover down on work
bench. Drum shaft should be in vertical position.
Set springs #75 & #76 into pockets of gear housing
with drag brakes #12 on top of disc #77and springs.
Apply grease to shaft and drum bushings. Slide
drum assembly #13 onto drum shaft with drum jaws
upward as shown.
FIGURE 15
13