RAMSEY WINCH H 49,8 Série Traduction Des Instructions Originales page 12

FIGURE 10
Check clutch housing bushing #41 for wear. If nec-
essary, remove old bushing and press new bushing
into place. Apply grease to lube fittings #65 to lubri-
cate clutch shifter shaft.
FIGURE 10
FIGURE 11
Check cover bushing #6 and quad ring #67 for
signs of wear. Replace if necessary by pressing old
bushing from gear housing cover #10. Press new
bushing into place and insert new quad ring #67
into groove inside of bushing.
FIGURE 11
FIGURE 12
Apply grease to end of shaft #29, opposite gear #16.
Apply grease to bushing in gear housing #20. Place
greased end of shaft through bushing in gear hous-
ing #20. Place gasket #64 onto gear housing cover
#10. Apply grease to gear end of shaft and cover
bushing. Place cover onto shaft and secure to hous-
ing with seven #46 and one #45 capscrews. Tighten
capscrews to 16.1 Nm (12 ft lb) each.
FIGURE 12
12