Wiring Installation; Installing The Ups - Eaton 9130 Guide D'installation

Wiring Installation

EATON 9130 (9910-E15/E16) UPS Installation Guide for IBM
This section explains:
S
Installing the UPS, including connecting the UPS internal batteries
S
Connecting any optional EBMs

Installing the UPS

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
NOTE Do not connect the UPS power cord to utility until after installation is completed.
To install the UPS:
1. Remove the UPS front cover (see Figure 1).
To remove the cover, push down on the top of the cover and pull
the cover toward you to unclip it from the cabinet.
NOTE A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable
or disconnect it.
NOTE Leave
ribbon cable
connected.
Figure 1. Removing the UPS Front Cover
S
® Applications 164201783 Rev 2
INSTALLATION
9