Ups Monitoring On The System I And As/400 - Eaton 9130 Guide D'installation

INSTALLATION

UPS Monitoring on the System i and AS/400

16 EATON 9130 (9910-E15/E16) UPS Installation Guide for IBM
NOTE The internal batteries charge to 90% capacity in less than 3 hours. However, Eaton
recommends that the batteries charge for 48 hours after installation or long-term storage.
15. Keep your UPS firmware updated. See the UPS user's guide for
more information.
If you have questions about either the E15 or the E16 UPS, the following
options are available:
S
For product information, visit www.eaton.com/ibm.
S
For answers to frequently asked questions, visit our FAQ database at
www.eaton.com/ibm and select General Knowledge > Frequently
Asked Questions.
S
If your question is not in the FAQ database, submit the question to
"Ask the Expert" at www.eaton.com/ibm.
S
If you need additional information, contact the IBM office or Business
Partner servicing your account.
To set the system for UPS monitoring:
1. Set the QUPSDLYTIM system value for the UPS monitoring
feature.
2. UPS monitoring is a standard feature of the System i (AS/400)
operating system. QUPSDLYTIM is a timer that tells the system
how long to run on UPS power before shutting down. Each system
is initially assigned a default value for QUPSDLYTIM. A complete
description of QUPSDLYTIM is provided on the AS/400 Information
Center Internet Site at:
http://publib.boulder.ibm.com/pubs/html/as400/ic2924/info/index.htm
Select System Administration and Maintenance.
The *NOMAX value tells the AS/400 to use customized shutdown software, and if none is
available it will begin shutdown immediately when utility power fails. Do not set
QUPSDLYTIM to "*NOMAX" unless you understand the implications of the "*NOMAX"
function as described at the AS/400 Information Center Internet Site.
C A U T I O N
S
® Applications 164201783 Rev 2