Operating Modes; Normal Mode; Battery Mode - Eaton 9130 Guide D'installation

OPERATION

Operating Modes

20 EATON 9130 (9910-E15/E16) UPS Installation Guide for IBM
The Eaton 9130 front panel indicates the UPS status through the UPS
indicators (see Figure 7 on page 18).

Normal Mode

During Normal mode, the
powered from the utility. The UPS monitors and charges the batteries as
needed and provides filtered power protection to your equipment.
The UPS may at times silently implement a High Alert mode, usually
when incoming utility conditions are unfavorable. In High Alert mode,
the UPS disables the battery support test to ensure maximum capacity
from the batteries if needed. The UPS will remain in High Alert for
24 hours or until changed by a Power Strategy command before
returning to its previous mode.
Optional High Efficiency and Energy Saving settings minimize heat
contribution to the rack environment. See "User Settings" in the UPS
user's guide.

Battery Mode

When the UPS is operating during a power outage, the alarm beeps
once every five seconds and the
When the utility power returns, the UPS transfers to Normal mode
operation while the battery recharges.
If battery capacity becomes low while in Battery mode, the
flashes slowly and the audible alarm beeps once every second. If the
"Battery Low" alarm is set, the
warning is approximate, and the actual time to shutdown may vary
significantly.
NOTE Depending on the UPS load and the number of Extended Battery Modules (EBMs)
connected, the "Battery Low" warning may occur before the batteries reach 25% capacity.
Refer to the UPS user's guide for estimated runtimes.
When utility power is restored after the UPS shuts down, the UPS
automatically restarts.
indicator illuminates solid and the UPS is
indicator illuminates solid.
indicator also illuminates solid. This
S
® Applications 164201783 Rev 2
indicator