Step 3: Adjusting The Picture Size And Position - Sony VPL-HS10 Mode D'emploi

Step 3: Adjusting
the Picture Size
and Position
LIGHT INPUT
DYNAMIC STANDARD CINEMA
PICTURE MODE
USER 1 USER 2 USER 3
ENTER
APA MS SLIDE MENU
WIDE MODE LENS RESET
VOLUME SIDE SHOT
+ +
– –
Tip
The ? / (on/standby), INPUT, MENU, and m/M/</,/
1
ENTER (joystick) buttons on the side panel of the projector
function the same as those on the remote control.
16

Step 3: Adjusting the Picture Size and Position

GB
Rear remote control
detector
6
5,7
Adjuster adjustment
button
Front remote control
detector
2
4
6
1
Plug the AC power cord into a
wall outlet.
The ON/STANDBY indicator lights in red and
the projector goes into standby mode.
STANDBY
2
Press the [/1 (on/standby)
switch to turn on the projector.
The ON/STANDBY indicator lights in green.
3
Turn on the equipment
connected to the projector.
Refer to the operating instructions of the
connected equipment.
4
Press INPUT to project the
picture on the screen.
Each time you press the button, the input
indication changes. (1 page 21)
INPUT
5
Adjust the focus roughly using
the FOCUS +/– button.
ON/
Lights in red.
ON/
STANDBY Lights in green.
V i d e o 1
NTSC 3.58
FOCUS +/– button