Step 4: Selecting The Menu Language - Sony VPL-HS10 Mode D'emploi

When projecting from the center
Adjust so that both the position and size of
the bottom side of the picture fit those of the
bottom side of the screen using the adjuster
and the ZOOM+/– button.
If you set "V Keystone" in the INSTALL SETTING
menu to "Auto" (1 page 29), the vertical distortion
will be automatically corrected.
For how to use the adjuster, see "Using the adjuster."
Screen
Picture
Note
The V Keystone adjustment may not correct trapezoidal distortion
perfectly, depending on the room temperature or the screen angle.
7
Press FOCUS +/– to adjust the
focus again.
Using the adjuster
Adjuster
Use the adjuster to adjust the picture position.
Lift the projector while pressing the adjuster
adjustment button, and release the button.
Holding the adjuster adjustment button pressed,
move the projector, then release the button at the
locked position.
18

Step 4: Selecting the Menu Language

GB
Tip
When you press FOCUS +/– or ZOOM +/– in steps 5 to 7,
the built-in signal pattern is projected on the screen. If you
want to adjust the focus and picture size using the current
input signal, set "Test Pattern" in the INSTALL SETTING
Step 4:
Selecting the
Menu Language
You can select one of nine languages for displaying
the menu and other on-screen displays. The factory
default setting is English.
Adjuster
adjustment
button
Tip
You can operate the menu using the joystick on the side panel of
the projector instead of the M/m/</,/ENTER buttons on the
remote control.
menu to "Off." (1 page 29)
2
LIGHT INPUT
DYNAMIC STANDARD CINEMA
PICTURE MODE
USER 1 USER 2 USER 3
4-6
ENTER
3
APA MS SLIDE MENU
WIDE MODE LENS RESET
VOLUME SIDE SHOT
+ +
– –