Step 3: Adjusting The Picture Size And Position - Sony VPL-HS3 Mode D'emploi

Step 3: Adjusting
the Picture Size
and Position
5,7
5,8
LIGHT INPUT
DYNAMIC STANDARD CINEMA
PICTURE MODE
USER 1 USER 2 USER 3
ENTER
APA DDE MENU
WIDE MODE MUTING RESET
VOLUME SIDE SHOT
+ +
– –
Tip
The ? / (on/standby), INPUT, MENU, and M/m/</,/
1
ENTER (joystick) buttons on the side panel of the projector have
the same functions as those on the remote control.
Rear remote control
detector
Ajuster lock lever
Front remote control
detector
4
2
M/m/</,/
ENTER buttons
RESET button
7
1
Plug the AC power cord into a
wall outlet.
The ON/STANDBY indicator lights in red and
the projector goes into standby mode.
ON/
STANDBY
2
Press the [/1 (on/standby)
switch to turn on the projector.
The ON/STANDBY indicator lights in green.
3
Turn on the equipment
connected to the projector.
Refer to the operating instructions of the
connected equipment.
4
Press INPUT to project the
picture on the screen.
Each time you press the button, the input
indication changes. (1 page 23)
INPUT

Step 3: Adjusting the Picture Size and Position

Lights in red.
Lights in green.
ON/
STANDBY
V i d e o 1
NTSC 3.58
15
GB