Others; Troubleshooting - Sony VPL-HS3 Mode D'emploi

Others

This section describes how to solve the
problems, how to replace a lamp and air
filter, etc.

Troubleshooting

Power
The power is not
turned on.
34
Troubleshooting
GB
c Wait for about one minute
before turning on the power.
(1 page 24)
c Close the lamp cover securely.
(1 page 36)
c Close the air filter cover
securely. (1 page 38)
Picture
c Check that the proper
No picture.
connections have been made.
(1 page 9)
c Select the input source correctly
using the INPUT button.
(1 page 23)
c Set the computer signal to output
from an external monitor.
c Set the computer signal to output
only to an external monitor.
c Select "Computer",
"Component" or "Video GBR"
for "Input-A Signal Sel" in the
SET SETTING
according to the input signal.
(1 page 31)
c Select "Computer",
The picture from the PJ
MULTI connector is
"Component" or "Video GBR"
colored strange.
for "Input-A Signal Sel" in the
SET SETTING
according to the input signal.
(1 page 31)
c Adjust the picture in the "Adjust
Color balance is
incorrect.
Picture ..." of the PICTURE
SETTING
(1 page 29).
c Set "Color System" in the SET
SETTING
the color system being input.
(1 page 31)
The picture is too dark. c Adjust the contrast or brightness
in the "Adjust Picture ..." of the
PICTURE SETTING
properly. (1 page 29)
The picture is not clear. c Adjust the focus with the
FOCUS ring. (1 page 23)
c Condensation has occurred on
the lens. Leave the projector for
about two hours with the power
on.
The picture flickers. c Adjust "Dot Phase" for "Adjust
Signal..." in the INPUT
SETTING
(1 page 30)
menu
menu
menu
menu to match
menu
menu properly.