Others; Troubleshooting - Sony VPL-HS1 Mode D'emploi

Others

This section describes how to solve the problems, how to
replace a lamp and air filter, etc.

Troubleshooting

Symptom
The power is not turned on.
No picture.
The picture from the PJ MULTI
connector is colored strange.
Color balance is incorrect.
The picture is too dark.
The picture is not clear.
34
Troubleshooting
GB
Cause and Remedy
• The power has been turned off and on with the [/ 1 (on/standby) switch at a
short interval.
c Wait for about one minute before turning on the power (1 page 15).
• The lamp cover is detached.
c Close the lamp cover securely (1 page 38).
• The air filter cover is detached.
c Close the air filter cover securely (1 page 39).
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (1 pages 8 and 9).
• Input selection is incorrect.
c Select the input source correctly using the INPUT button (1 page 15).
• The computer signal is not set to output to an external monitor.
c Set the computer signal to output to an external monitor.
• The computer signal is set to output to both the LCD of the computer and
external monitor.
c Set the computer signal to output only to the external monitor.
• Setting for INPUT-A in the SET SETTING
c Select COMPUTER, COMPONENT or VIDEO GBR for INPUT-A in the
SET SETTING menu according to the input signal (1 page 20).
• Picture has not been adjusted properly.
c Adjust the picture in the PICTURE CTRL
• Projector is set to wrong color system.
c Set COLOR SYS in the PICTURE CTRL
system being input (1 page 19).
• Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the PICTURE CTRL
(1 page 19).
• Picture is out of focus.
c Adjust the focus with the focus lever (1 page 15).
• The lens cap is attached to the lens.
c Remove the lens cap.
• Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
menu is incorrect.
menu (1 page 19).
menu to match the color
menu properly