Sony VPL-HS1 Mode D'emploi page 36

Indicators
The LAMP/COVER or TEMP/FAN indicator on the control panel lights up or flashes if there is any trouble with
your projector.
Indicator
LAMP/COVER flashes.
LAMP/COVER lights
up.
TEMP/FAN flashes.
TEMP/FAN lights up.
LAMP/COVER and
TEMP/FAN light up.
Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
High temp.!
Lamp off in 1 min.
Frequency is out of
range!
Please check INPUT-A
setting.
Please replace the
LAMP.
Please replace the filter.
36
Troubleshooting
GB
LAMP/ TEMP/
COVER FAN
TEMP/FAN Indicator
LAMP/COVER Indicator
Meaning and Remedy
• The lamp cover or the air filter cover is detached.
c Attach the cover securely (1 pages 38 and 39).
• The lamp has reached the end of its life.
c Replace the lamp (1 page 38).
• The lamp becomes a high temperature.
c Wait for one minute to cool down the lamp and turn on the power again (1 page 15).
• The fan is broken.
c Consult with qualified Sony personnel.
• The internal temperature is unusually high.
c Check to see if nothing is blocking the ventilation holes.
• The electrical system breaks down.
c Consult with qualified Sony personnel.
Meaning and Remedy
• Internal temperature is too high.
c Turn off the power.
c Check to see if nothing is blocking the ventilation holes.
• This input signal cannot be projected as the frequency is out of the acceptable range of the
projector.
c Input a signal that is within the range of the frequency.
• The resolution setting of the output signal of a computer is too high.
c Set the setting of output to SVGA.
• You have input RGB signal from the computer when INPUT-A in the SET SETTING
menu is set to COMPONENT or VIDEO GBR.
c Set INPUT-A correctly (1 page 20).
• It is time to replace the lamp.
c Replace the lamp (1 page 38).
• It is time to replace the air filter.
c Replace the air filter (1 page 39).
POWER ON/
SAVING STANDBY