Beurer EA 34 Mode D'emploi page 31

Stimulation
Ensure that the device is switched
off. Then move the [0] switch to the
T position and switch the device
back on again.
The device is switched on by pressing the
On/off button [10] on the control panel.
• Select the desired stimulation mode by
pressing the mode button [12] on the
control panel.
• Please note that after it has been swit-
ched on, the device will be in search
mode, which is not required for TENS
use. Please skip this mode by pressing
the mode button [12].
• Increase the intensity in stages by re-
peatedly pressing the intensity buttons
+ / – [9, 11] on the control panel.
• To switch stimulation mode, press the
mode button [12] on the control panel.
Please note the selected intensity set-
ting is not retained when switching sti-
mulation mode, and will therefore need
to be set again.
Stimulation continues until you switch sti-
mulation mode or switch off the device us-
ing the On/off button [10] on the control
panel.
Duration of use
Select a duration that is comfortable, up to
a maximum of 15 minutes.
If you start to feel pain, stop using the unit
immediately and select another intensity
level if necessary.
Intervals for use
Use the unit multiple times a week as nee-
ded.
Important
During TENS use there is also a current at
the acupuncture tip. Please do not touch
it.
Please also note that no object should be
inserted into the connection for the elec-
trode cable. This can considerably limit its
function.
Cleaning and storage
Adhesive electrodes:
• In order to make sure that the elec-
trodes continue to stick for as long as
possible, they should be carefully
cleaned with a damp, lint-free cloth.
• After use, stick the electrodes back onto
the backing film.
31