Basic Safety Instructions - Burkert T-CUT Manuel D'utilisation

Type T-CUT
BasicSafetyInstructions
3 BASIC SAFETY INSTRUCTIONS
These safety instructions do not make allowance for any
• contingencies and events which may arise during assembly, operation, and maintenance of the product.
• local safety regulations - the operator is responsible for observing these regulations, also in relation to the instal-
lation personnel.
DANGER!
Risk of poisoning, chemical burns, contamination from escaping medium.
▶ Check the product for leak-tightness prior to commencing use.
▶ When handling hazardous substances, always take appropriate precautionary measures and wear personal
protective equipment in accordance with the requirements of the medium.
▶ Before disconnecting lines, the medium must be flushed from the entire system.
Risk of injury from high pressure in the system/product.
▶ Before working on the system or product, switch off the pressure and vent/drain the lines and product.
General hazardous situations:
To prevent injuries:
▶ Ensure that the system cannot be activated unintentionally.
▶ Installation and maintenance work may be carried out only by authorized technicians with the appropriate tools.
▶ After an interruption in the filtration process, ensure that the process is restarted in a controlled manner.
▶ The product may be operated only when in perfect condition and in consideration of the operating instructions
and product-specific data sheet.
▶ The general rules of technology apply to application planning and operation of the product.
To prevent damage to the product:
▶ Protect the product from excessive exposure to UV radiation and from frost.
▶ Do not allow the product to come into contact with organic solvents. Remove contaminants with water or
approved cleaning agents.
▶ Protect the product from impacts.
▶ Do not back-flush the device.
▶ Always keep the interior of the product in a moist state.
▶ Do not exceed the maximum pressure drop.
▶ The pressure on the permeate side must never be higher than on the feed side.
▶ At the maximum permitted temperature, the module must not be operated at pressures higher than those speci-
fied in the product-specific data sheet.
▶ Do not make any external modifications to the product.
▶ Pressure surges, sudden increases in the solid content of the feed, heavy cross-flow drops and temperature
shocks must absolutely be avoided.
▶ Only feed in the media types specified in Section "7.4.1 Compatible Media" to the media connections. The use
of unnamed media is the responsibility of the user.
▶ Do not place a physical load on the module (e.g. by placing objects on it or standing on it).
The T-CUT tubular/pipe module has been developed with due consideration to recognized safety standards
and is consistent with the latest technological developments. Nevertheless, dangerous situations may occur.
english
7