Returning A Module; Packaging And Transport - Burkert T-CUT Manuel D'utilisation

Type T-CUT
ReturningaModule
14 RETURNING A MODULE
Please contact a representative of Bürkert Fluid Control Systems before sending back a module.
Prepare the module as if you were preparing it for long-term storage ("13.2.2 Long-term Storage"). Send the
module well-packed to Bürkert Fluid Control Systems with an enclosed written statement of the faults identified.
15 PACKAGING AND TRANSPORT
NOTE!
Transport damage.
Inadequately protected products may be damaged during transportation.
▶ Protect the product against light, moisture and dirt in shock-resistant packaging during transportation.
▶ Prevent the temperature from exceeding or dropping below the permitted storage temperature.
▶ Storage temperature 5 ... 30 °C.
Damage to the environment caused by parts of the product contaminated with media.
▶ Dispose of the product and packaging in an environmentally friendly manner.
▶ Observe applicable waste disposal and environmental regulations.
english
23