Disassembly - Burkert T-CUT Manuel D'utilisation

11

DISASSEMBLY

DANGER!
Risk of poisoning, chemical burns, contamination from escaping medium.
▶ When handling hazardous substances, always take appropriate precautionary measures and wear personal
protective equipment in accordance with the requirements of the medium.
▶ Before disconnecting lines, the medium must be flushed from the entire system.
Risk of injury from high pressure in the system/product.
▶ Before working on the system or product, switch off the pressure and vent/drain the lines.
Risk of injury from improper disassembly.
Improper disassembly may result in injuries as well as damage to the product and the area around it.
▶ Before removal, ensure that the operating personnel are familiar with and completely understand the contents
of the operating instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may remove the product.
If the T-CUT tubular/pipe module is to be used further after removal, certain conditions must be adhered to
regarding storage (refer to "13 Non-use/Module Storage").
Procedure:
→
Completely drain the system.
→
Flush out the rest of the feed solution with water (normal cold tap water) until the concentrate is clear.
→
Flush the entire system for 20 minutes using warm water. Any concentrate or permeate generated is to be
disposed of.
→
Completely drain the system.
→
Disconnect the connections.
→
Remove the product.
Please consult a representative of Bürkert Fluid Control Systems if you have any questions.
20
english
Type T-CUT
Disassembly