Troubleshooting - Sony MSAC-PR1 Mode D'emploi

Troubleshooting

Before sending the equipment for repair, please check the
following points. If the equipment still fails to function
normally after you have checked everything, consult your
local Sony service personnel.
Please refer to your PC Operating Manual.
Symptom
Cause/Action
Cause/Action
Cause/Action
Symptom
Cause/Action
GB
22
The MSAC-PR1 connector is connected to a printer but an
error occurs and printing cannot be done.
Or, reading/writing data cannot be done to the PC card.
There is some permanent application that keeps watch over
the state of the printer. Printing cannot be done and the
computer does not recognize the PC card in the normal way.
Close the permanent application.
The parallel port settings on the computer are incorrect.
Try changing the BIOS settings.
The printer is incompatible with this device.
Some printers cannot be used when connected to the MSAC-
PR1 printer connector.
When writing or reading from Memory Stick, a disk
writing error is displayed on a blue screen, with a warning
message that files or data may have been lost.
The Memory Stick erase protect switch is set to the "LOCK"
position.
Release the LOCK on the Memory Stick. The data in the
Memory Stick will not be lost.