Sony MSAC-PR1 Mode D'emploi page 16

B Adding MSAC-PR1 device driver parameters (for Windows 95/98
only)
If the MSAC-PR1 does not function normally, add device driver parameters
according to the following procedure.
1 Select "Properties" from the context menu when you right click over "This
Computer" or double click "System" in the control panel to open the
system properties window.
2 Double click the device manager tab, then double click SCSI controller
category to display "Sony MSAC-PR1" in the device list.
3 Double click "Sony MSAC-PR1" to display the Properties window and then
click the Settings tab.
4 The adaptor setting will be "/flash/W95." Add "/ni /de /di" to this and click
"OK," making sure there is a space before each slash.
GB
14