Sony MSAC-PR1 Mode D'emploi page 13

Further, If the "Hardware Initialization Failure" window
appears, select "I will connect the MSAC-PR1 later" to shut down
the setup, and then recheck the connections.
• Make sure the 25-pin connector is firmly connected to the
parallel port.
• The power to the MSAC-PR1 must be on. Insert the power
connection cable associated with the keyboard connector of the
PC, and connect it to the DC jack of the MSAC-PR1.
If the "Removable Disk" icon does not appear on restarting the
PC even with the PC card inserted, it may be that the BIOS
settings in the PC are not set correctly for MSAC-PR1. You will
need to change the BIOS settings.
For details, refer to "Changing Settings for Installation" A (page
13) and B (page 14) to change the BIOS settings.
GB
11