Scheppach OSM100 Traduction Des Instructions D'origine page 13

Prepare the appropriate tool and mount it as follows:
1. Attach the lower spindle disc (16) to the spindle (4)
(fig.2).
2. Insert the table inlays (5) into the table (fig. 3).
3. Attach the lower spindle disc (6) to the spindle (4)
(fig.2).
4. Slide the abrasive sleeve (7) onto the rubber sleeve
(6) (fig. 5).
5. Apply the disc (13) (use the correct measurements)
(fig. 6).
6. Put on the hex-nut and tighten it with the hook
wrench (14). (fig. 7)
Be sure always to mount the correct parts when chang-
ing the abrasive sleeves. The table inlays have to be big-
ger than the abrasive sleeves. (fig. 8)
Note! The 13 mm abrasive sleeve is put directly onto the
spindle (4).
Table:
Abrasive sleeve Table inlay
inside D inside D
13 mm 18 mm
19 mm 25 mm
26 mm 31 mm
38 mm 44 mm
51 mm 57 mm
76 mm 82 mm
Initial operation
After completing all assembly and setup work, turn on
the machine and while it idles, check that the spindle can
move faultlessly. In the case of disturbances, turn the
machine off immediately and rectify the cause.
Once the machine has reached its maximum revolution
speed you ay start the grinding work.
Move the work piece slowly in the direction contrary to
the running direction of the grinding roll.
Do not overload the machine by too much pressure
against the grinding roll.
After finishing the grinding turn off the machine and dis-
connect the main plug.
ATTENTION!! Use dust mask, protective goggles
and vacuum extraction.
m Electrical connection
The installed electric motor is factory connected ready
for operation. The connection meets the applicable VDE
and DlN regulations.
The connection made by the customer as well as any ex-
tension cables used must comply with all relevant regu-
lations.
Connection and repair work on the elctric equipment
must be carried out by a qualified technician only.
Important note
The motor rating is S 1. This means that when overload-
ed it switches off automatically. After a cooling period
(can vary) you may switch it on again.
Disconnect the main plug before conducting any
maintenance work.
Cleaning the machine after every use is recommended.
Keep the safety devices, air boxes and the crankcase
clean.
Clean the machine with a cloth.
Do not use any solvents or cleaning agents because
they could harm the plastic parts of the device.
Do not let water get into the interior of the machine.
The interior of the machine is completely maintenance-
free.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consumables.
Wear parts*: grinding medium, Carbon brushes, sharp-
ening wheel, angle gauge, v-belt
Spindle disc
size
* Not necessarily included in the scope of delivery!
small 16 mm
medium 20 mm
medium 20 mm
large 35 mm
large 35 mm
large 35 mm
m Maintenance
english 13