Operation - Qlima PGP 113 Manuel D'utilisation

WARNING! The black silicone ring must be in place prior to operating the
heater.
Step 8: pic. 10
• Assembly the protective guard. Hang the hooks of the protective guard onto
the holes in supports. Secure the protective guards with fixing brackets with 4
pcs 3/16" screws.
Step 9: pic. 11
• Attach the three side panels to the heater using 18 pcs screw 3/16".
Note : Do not cover the front side where the control knob is.
Step 10: pic. 12
• Install the knob to M4X6 screw. Hang the chain to the hole on the control
box assy and put the pothook of front panel to the holes of bottom plate.
Step 11: pic. 13
• Connect the gas hose and regulator after that connect the regulator to the
gas cylinder.
WARNING! Ensure the hose does not contact any high temperature surfaces,
or it may melt and leak causing a fire. After the cylinder is placed inside the
heater, secure the cylinder with block belt tightly.

OPERATION

• Connect the gas hose to the gas connector. (pic. 14)
Please note:
- The gas hose is NOT included with the heater. Hose must be purchased sepa-
rately
- Minimum / Maximum length gas hose: 60-80 cm
- Screw connection (France G1/2) is fitted as standard
- Hoses 8-13 mm. can be fitted as well. When required: use the multi country
connector supplied. Fitting of the multi country connector is described in the
separate manual supplied in with the included multi country kit. When using
the multi country connector: ALWAYS make sure to use hose clamps!
• For gas hose with threaded connectors: bind 2 or more rounds of plumbing
tape around the gas pipe before connecting the gas hose for security.
• Bind 2 or more rounds of Teflon plumbing tape around the gas burner inlet
connector and connect the gas pipe. Use a wrench to tighten the connection.
• Connect the other end of your gas hose according to the mounting instruc-
tion as supplied with the gas hose and/or supplied with the gas regulator.
Note:
- The gas hose is NOT included with the heater
- The gas regulator is not included with the heater
• Connect the regulator to the gas cylinder (not included) according to the
4
43