Qlima PGP 113 Manuel D'utilisation page 44

•
LIGHTING INSTRUCTION
•
•
TO TURN ON THE HEATER
Check that the regulator seal is correctly fitted and able to fulfil its function.
a)
b)
c)
Note:
1.
2.
3.
d)
e)
E
Lo
Hi
TO TURN OFF THE HEATER
a)
b)
c)
4
44
mounting instruction as supplied together with the gas regulator and/or the
gas cilinder
Put gas cylinder on the base.
Check and ensure that an AA battery is inside the ignition chamber. Use a
new battery so you are sure the battery is full of power.
Ensure that the '+' side of the battery is facing outside (so '+' faces towards
the user)
Open the valve on the gas supply cylinder.
Press and turn the variable control knob to PILOT position (counter-clockwise
90°).
Press down the variable control knob and hold for 30 seconds. While holding
down the variable control knob press the igniter button several times until
the pilot flame ignited. Release the variable control knob 10~20 seconds after
the ignition.
If a new tank has just been connected, please allow at least one minute or
more for the air in the gas pipeline to purge out through the pilot hole,
When lighting the pilot flame make sure that the variable control knob is
continuously depressed while pressing the igniter button. Variable control
knob can be released after the pilot flame lit for 10-20 seconds.
Pilot flame can be watched and checked from the peephole Iocated on the
base of burnerhead . If the pilot flame does not light or it goes out, repeat
step c.
Turn the variable controI knob to LO and Ieave it there for 5 minutes or more
before turning the knob to desired temperaturesetting.
If the burner flame goes out accidentally or it is blown out by wind, turn off
the heater and wait at Ieast 5 minutes or more to let the gas dissipate before
re-lighting to avoid possible gas explosion. Repeat steps b to d.
FR GB
Off Off
Position Ignite posi-
d'allumage tion
Capacité Low capa-
faible city
Capacité High capa-
élevée city
Table 1
Turn the variable control knob to PILOT position.
Press and turn the variable control knob to OFF position.
Turn off the valve on the gas cylinder and disconnect the cylinder.
IT N
Spenta
Posizione di
accensione
Bassa capa-
cità
Alta capa-
cità
NL
Uit
Ontstekings
positie
Laag ver-
mogen
Hoog ver-
mogen