Cleaning And Care; Troubleshooting - Qlima PGP 113 Manuel D'utilisation

CLEANING AND CARE

Warning: Make sure the heaer is in off position and is cool!
Warning: Do not clean heater with cleaners that are combustible or corrosive.
•
•
•
•
•
•
•

TROUBLESHOOTING

4
46
Wipe off powder coated surfaces with soft, moist rag and soap water.
Remove debris, spider and insect nests from ventilation opening of the cylin-
der enclosure, control compartment, burner and circulation air passageways
of the heater with heavy duty pipe cleaner or compressed air to keep appli-
ance clean and safe for use.
Never clear ports or other openings with toothpic.ks or other article that will
break and block the ports.
If carbon deposits develop, remove the reflector and flame screen and clean
them with soap water.
Do not paint the flame screen, control panel or reflector.
Cover the burner unit with the optional supplied protective cover when the
heater is not in use. Wait until the heater is cool before covering.
In a salt-air environment, such as near an ocean, corrosion occurs more
quickly than normal. Check frequently for corroded areas and repair them
promptly.
Review these tips first and you may not need to call for service.
Problem Probable cause
Gas valve may be OFF
Tank fuel empty
Pilot injector blocked
Air in supply system
Pilot will not light
Loose connections
Low gas pressure
Battery is empty
Lack of fuel pressure
Pilot will not stay on
Debris around pilot
Loose connections
Thermocouple bad
Gas Ieak in Iine
Solution
Turn the gas valve ON.
Refill gas tank.
Clean or replace pilot injec-
tor.
Purge air from lines by pres-
sing the control knob until
you smell gas.
Check all fittings.
Replace cylinder with a new
cylinder.
Replace battery with a full
battery
Keep the variable knob
depressed for 10-20 seconds
or more after the pilot light
ignited.
Tank near empty. Refill gas
tank.
Clean dirty area.
Tighten connections.
Replace thermocouple.
Check connections.