End Of Life Time - Qlima PGP 113 Manuel D'utilisation

Burner will not light
Burner flame is low
Burner flame goes
off immediately
after ignition
Emitter glows une-
ven
Thick black smoke
Carbon bulld-up

END OF LIFE TIME

If it is decided that the gas heater is not to be used any more, it is recom-
mended that it be disconnected from the gas container. Also cut the rubber
hose. If children play with the heater, make sure that dangerous parts are
removed.
Never dispose of non-biodegradable products in the environment, but dis-
pose of them in accordance with current national legislation. At the end of
its lifetime, the product must not be disposed of as urban waste. It must be
taken to a special local authority differentiated waste collection center or to
a dealer providing this service.
Disposing of a household appliance separately avoids possible negative con-
sequences for the environment and health deriving from inappropriate dis-
posal and enables the constituent materials to be recovered in order to make
significant savings in energy and resources. As a reminder of the need to dis-
pose of household appliances separately.
Pressure is low Tank near empty.Refill gas
tank.
Opening blocked Remove and clean.
ControI is not 0N Turn valve to ON.
Thermocouple bad Replace thermocouple.
Pilot light assembly Place pilot properly.
bent
Not in correct location Position properly and retry.
Supply hose is bent or Straighten hose and per-
twisted form leak teston hose.
Blockage in burner Clean or replace burner
injector injector.
Low gas pressure Let the pilot flame stay lit
for 10 minutes before set-
ting variable knob to LO.
Blockage in burner Clean or replace burner
injector injector
Base is not on a leveI Place heater on a IeveI
surface surface
Low gas pressure Replace cylinder with a new
cylinder.
Blockage in burner Turn off the heater and Iet
it cool.
Remove blockage and clear
burnerinside and outside.
Dirt or film on reflec- Clean reflector and flame
tor and flame screen screen.
4
47