Operation - Qlima PGC 3009 Manuel D'utilisation

man_PGC 3009 ('20) V5.indd 69 man_PGC 3009 ('20) V5.indd 69

OPERATION

• Connect the gas hose to the gas connector.
Please note:
- The gas hose is NOT included with the heater. Hose must be purchased sepa-
rately
- Minimum / Maximum length gas hose: 60-80 cm
- Gas connector suitable for:
- Ø 8-12 mm hose (all EU countries except France)
- G1/2'' (France only)
• For gas hose with threaded connectors: bind 2 or more rounds of plumbing
tape around the gas pipe before connecting the gas hose for security.
• Bind 2 or more rounds of Teflon plumbing tape around the gas burner inlet
connector and connect the gas pipe. Use a wrench to tighten the connection.
• Connect the other end of your gas hose according to the mounting instruc-
tion as supplied with the gas hose and/or supplied with the gas regulator see
picture 9.
Note:
- The gas hose is NOT included with the heater
- The gas regulator is not included with the heater
• Connect the regulator to the gas cylinder (not included) according to the
mounting instruction as supplied together with the gas regulator and/or the
gas cilinder
• Put gas cylinder on the base.
WARNING! Ensure the hose does not contact any high temperature surfaces, or
it may melt and leak causing a fire. After the cylinder is placed inside the heater,
secure the cylinder with block belt tightly. The heater must be fixed on a stable
and strong table with a minimum height of 40cm from floor level.
TO TURN ON THE HEATER
Check that the regulator seal is correctly fitted and able to fulfil its function
Before starting, always do a leak test. See section "leak testing".
1. See picture 11
2. Make sure the turnable knob at right hand side is in 'off' position
3. Fully open the gas cylinder – make sure that gas can flow unhindered towards
heaters
4. Press and turn knob B to "PILOT" position.
5. Press down knob B and hold it pressed for 60 seconds. While keeping knob B
pressed, press ignitor button A several times until the pilot flame inside the
heater lights. Make sure to keep pressing knob B for 20-40 seconds after pilot
flame is lit.
6. 20-40 seconds after pilot flame is lit: release knob B and stop pressing ignitor
button A
7. Now turn the knob B to 'HIGH" position and leave it there for 5 minutes or
more before turning the knob to the desired temperature position.
4
69
19-11-20 14:46 19-11-20 14:46